Author Archives: isabellazuniga36

This week I worked on assembling the barn. Along the way I ran into a lot of problems due to not assembling as I created the parts. I started with assembling the barn doors and that caused me the most trouble. At first the brackets were too close for the pole to fit so IContinue reading “Barn Assembly”

This week I created the barn and all of the doors and attachments. I started by building the barn. Just like my sketch I made the front completely open. I added a roof on top and used the roof to frame the open part of the door. Next I created a cut where my slidingContinue reading “Barn and Doors”

This week I focused on designing the barn. I decided to go with an open front and a back that had sliding doors. The doors on the back are going to be the same as the doors I made for the cat house. The only difference is going to be that these doors are slidingContinue reading “Designing the Barn”

I was not able to do much this week but I was able to work on the wooden posts for the pitchfork and shovel along with the handles for them. For the posts I made it 1m in height and about 2 inches in diameter. This was a simple part to make, I sketched aContinue reading “Handles and post”

This week I worked on the shovel and the bales of hay. For the shovel I started with an extruded part that was the base shape of the shovel. I then went to the sides of the shovel and drew the curve the shovel will be. Next I worked on the hay bales. Right nowContinue reading “Shovel and Bales”

This week I began to work on the shelves, bookcase, and hay bales. I first started by working on the shelves since that was the least complicated, I created a 2.5m x 1m rectangle and extruded it upward .075m just like I did for the planks on the cat tree. I then began to workContinue reading “Shelves, Bookcase, and hay bales”

This week I continued to plan everything that is to go into the barn. I looked up the actual sizes of shovels, pitch forks, tractors, and hay bales in order to plan the sizing and placement of everything properly. In the first picture below you can see all of my designs with the placement andContinue reading “Barn Plans”

This week I designed the barn and I have provided a picture down below. I made notes of some questions I had while planning the barn. Some of the questions written I figured out while designing and some I am planning on asking at our next meeting. I am not sure if there are goingContinue reading “Barn Design”

Down below you can see my fully assembled cat tree. Due to a test I was not fully able to tweak my designs but I will continue tweaking and updating it in my assembly. As you can see in the picture the stairs are a different material, I need to go back and edit theContinue reading “Cat Tree Assembly”

My task for this week was to create a shower station for the cat house. I started by making the cat shower be the length of the wall but decided that it was too big. I then decided to use half of the wall for a shower. Of the remaining half I used two thirdsContinue reading “Cat Shower”